Tiny Penguin and Snowman

Print-in-place articulated Tiny Penguin and Snowman!
Keychain versions included!
Considerations:

• They are small and articulated. That means good bed adhesion is required. For tricky filaments that usually have worse adhesion I recommend using some kind of glue (my personal favourite is 3DLac spray).
• The "Standard" version is the original one. If you find adhesion issues with the head getting loose mid-print, then try the "Stabilized" alternative. Those have tiny built-in supports on the neck that help keeping everything together, and can be released by rotating the head after print.
• Inside each folder you will find a 3MF file and an STL folder. I've included all the 4 versions on the same 3MF file, which makes it tidier. Just delete/deactivate the ones you don't want to print 😉
• The Tiny Penguin has a small built-in brim for the wings. Easy to remove after printing. It has a couple of support dots in the armpits as well to help stabilize the wings during printing. It may feel a bit hard to open the wings on the first try, but should be loose after that.
• For the Tiny Snowman, I recommend printing them with 3 perimeters, or a solid threshold that makes the arms solid. Especially if you plan to use it as a keychain.
• To change colors easily, check my quick tutorial.

Check here for Commercial License

A good first layer is mandatory for the print to succeed. Be sure your printer is calibrated and you have good bed adhesion.

I recommend a slow and thick first layer (8 mm/s and 0.3 mm).
Good layer cooling is also recommended, as it prevents curling and warping on overhangs.

For more tips, take a look at my printing tips.