Rocket Switch Dock - Classic and OLED

Print-in-place
No Support Needed
For Switch OLED and Classic. Check my designs for other consoles

This model is super cool and fun to print. It lets you dock your Switch in style and launch it into space (not literally, of course). It has a sleek design and a rocket-shaped stand that holds your Switch securely.

The best part is, everything is print-in-place, and no support is needed.

You only have to screw the thrusters in the rocket and then the rocket to the fuel.

Just load the file, hit print, and enjoy your Rocket Dock!

To successfully dock, slide the dock into the rocket by gently pushing the rocket's walls. It may require a bit of precision due to the tight fit. Once secure, it won't move up or down.

In my opinion, it seems quite stable and not prone to being knocked over easily. However, if you desire a more secure hold, utilizing velcro or 3M double-sided tape should do the job effectively.

⭐⭐⭐⭐⭐
IMPORTANT NOTE:
If you want to sell 3D prints based on my designs legally, please become a supporter on the platform of your liking:
🔵Thangs - www.thangs.com/designer/Holoprops
🟠Patreon - www.patreon.com/holoprops

All my Designs are covered by a Creative Commons Non-Commercial License on Cults 3D. The sale of prints using my designs is the sole right of myself, the designer, and my active supporters to do so. Please understand every design is many days of work and multiple prototype prints to ensure quality.

Happy printing!

To get the best out of the STL file, please follow these guidelines:
• No support is needed to print this dock. Everything is Print-in-Place.
• Layer Height 0.2mm
• Nozzle 0.4mm
• Recommended infill 15%.
• Recommended Infill Pattern: Gyroid or Cubic

• Prepare and clean your bed for excellent adhesion.
• Make sure your bed is correctly leveled. Then check again :D
• Try to hide the seam and place it where nobody will pay attention.
• Make sure your printing and bed temperatures are adequate for the filament you are about to use.