Kawaii Dim Sums in a Cute Basket

*Kawaii Dim Sum Figurines in a Cute Basket *

These 3 adorable Dumplings or Bao will be the perfect coffee table and desk decor at your home and your office.
Guaranteed 100% Super Cute & Kawaii!

Basket size: Length&Width 15cm (5.9in) | Height 3cm (1.2in)

Dim Sum size: Length&Width 6cm (2.36in) | Height 4.7cm (1.85in)

Total weight: 172g (0.38lb)

3D modelled and 3D printed with love from our home studio.

No support needed!

Please, use some glue to assemble the parts.

IMPORTANT NOTE:

If you want to legally sell 3D prints based on my designs, please become a Patreon on my page:
www.patreon.com/holoprops

All of my Designs are covered by a Creative Commons Non-Commercial License. Sale of prints using my designs are the sole right of myself, the designer, and my active Patreons to do so. Please understand every design is days of work and multiple prototype prints to ensure quality.

Happy printing!

To get the best out of the STL file, please follow these guidelines:
• Layer Height 0.2mm
• No support is needed for any parts.
• Nozzle 0.4mm
• Recommended infill 20%.
• Infill Pattern: Gyroid

• Use a raft for the small parts (eyes, blush, mouths)
• Do not print over 50 mm/s. A lower speed like 40 or even 30 mm/s will always produce better results.
• Make sure your bed is correctly leveled. Then check again :D
• Try to hide the seam behind the cup and place it where nobody will pay attention.
• Make sure your printing temperature and bed temperature is adequate for the filament you are about to use.
• If you follow the recommended settings above, you do not need any support to print this item.