Crystal Controller Stand - PLAYSTATION / SWITCH / XBOX

Print-in-place
No Support Needed
Tested with the PS5 controller, Xbox One and Series X controller, and Nintendo Switch Pro Controller. (It surely works with more controllers, but you will have to find it out)

Here's the Crystal Controller Stand
Super easy to print in any color to go along with your TV or desk setup!
Check out my other Crystal Design for a matching Gaming Setup.

The model was carefully designed to keep your controller safe from falling and should resist some gentle knocks.

⭐⭐⭐⭐⭐
IMPORTANT NOTE:
If you want to sell 3D prints based on my designs legally, please become a supporter on the platform of your liking:
🔵Thangs - www.thangs.com/designer/Holoprops
🟠Patreon - www.patreon.com/holoprops

All my Designs are covered by a Creative Commons Non-Commercial License on Cults 3D. The sale of prints using my designs is the sole right of myself, the designer, and my active supporters to do so. Please understand every design is many days of work and multiple prototype prints to ensure quality.

Happy printing!

Filament on the picture: iSanmate Rainbow PLA

To get the best out of the STL file, please follow these guidelines:
• No support is needed. Everything is Print-in-Place.
• Layer Height 0.2mm
• Nozzle 0.4mm
• Recommended infill 15%.
• Recommended Infill Pattern: Gyroid or Cubic
• 2 walls are okay. 3 will get you some extra strength.

• Prepare and clean your bed for excellent adhesion.
• Please, choose a printing speed your printer can handle and provide the best quality outputs.
• Make sure your bed is correctly leveled. Then check again.
• Try to hide the seam and place it where nobody will pay attention (usually at the back).
• Make sure your printing and bed temperatures are adequate for the filament you are about to use.

Minimum Print Bed Size: 18x18x18cm