Skip to content

Makes created by the community

Did you 3D print this model?

Soap holder

3D model description

Soap holder

3D printing settings

Soap holder

  • 3D model format: STL

Tags

Creator

Followers Following 0
Downloaded 12100

+LAB is the new 3Dprinting lab of Politecnico of Milan. Our team is composed by designers and engineers conducting academic research on this amazing technology!

License

CC BY NC SA

Similar 3D files

Best sellers of the category Home


Add a comment

5 comments

I printed this today and it worked great.

I've tried to print this twice (v2) and after it gets down with the bottom (approximately) my printer kind of goes nuts and tries to over-adjust and then essentially, it is offset by about 2 inches and tries to continue printing, but obviously it can't because it is not continuing where it left off and is basically printing over open air, so strings are going everywhere and don't have anywhere to connect. I've never had this issue on other prints.

@ClaudeJanz @nhabbott You're right, sorry for this problem. There is now the good file and a V2 of the Box, you can download the creation again to get them.

Same comment as nhabbott: the plate hase no holes in it.

Could you send me the plate with the pattern .stl files?