7 comments

I’m not quite sure what you are trying to ask.

Hey, Thanks for the reply.

Lets try again: Is it attached to the skadis in a manner that you cant take it off easily? Or how are they attached to the board?

Okay I understand now. It’s attached by hooks into the skadis that does allow it to be removed but it is also a bit of a friction fit so it doesn’t come out easily.

Thanks!

Maby you can help me. Do you have or know of something that would be like your item but maby easier to remove? As I would like to get them off the skadis to put on the table and so on.

I don't have anything currently but that might be something I work on in the future.

2 bad. I was wondering though with some small changes wouldnt it be a more easy fit? Something I could probably even do myself.

Have you measured them with a caliper?

Not yet, but I will borrow one and get back to you.

Alright, the ArchiveX bottles are 30.150mm (or 1.187in); the Vallejo Metal Color bottles are 35.052mm (or 1.380in), and the Mr Hobby Surfacer jars are 45.466mm (or 1.790in).

So for the ArchiveX and Vellejo bottles these two should work
https://cults3d.com/en/3d-model/tool/skadis-paint-rack-30mm-v1
https://cults3d.com/en/3d-model/tool/skadis-paint-rack-36mm-v1
For the Mr Hobby I will have to make a new one for that.

Any progress on the Mr Hobby 46mm/40ml jar rack? Now that I've printed several of the other small racks, it looks like you could only fit three 46mm slots on the existing design... ideally, four would be perfect for my needs, but I'll take whatever I can get.

Sorry about the wait. I was in the middle of moving when you requested this. I'll see if I can get to it sometime soon.

No worries, thanks!

Would you have some where I can privately message you?

You can message/chat me on Reddit, same username as here.

That entirely depends on which size you are printing along with if you modify any of the print settings.

The instructions are in the files so I'm not quite sure what you mean by subscribe?

Ya, it's mainly the variations in the Skadis. I've had it slot in just fine on one and then not go in on another. It's mainly the paint that is too thick in one spot, so it does scrape away. But 90% of the time it's the correct size.

I designed it to be a pretty snug fit. But obviously some variations happen between the production of the Skadis and the rack. Sometimes the paint can be a little thicker on the Skadis from hole to hole. So if it isn't sloting in just sand the vertical sides of the pegs a little and you should be good. Sometimes a little bit of force is needed to push it into the hole.

I currently have some prototypes that I am working on for that sort of stuff. I am also working on a whole standalone hobby organization system.