Skip to content

Caution friends, this is not a private messaging but a public discussion thread. It is a place of exchange, thank you for being courteous and respectful. Any commercial or malicious solicitations will be removed. Have a good discussion!

Write your message:

5 comments

Hi there - I purchased your hive drawers back in mid 2020. I had fair luck but the interlocking shells have been simply too tight and require sanding and such. I'm looking to know if maybe there was an update to the STL since I see a later updated date on the cult3d page or if you have advice to make this a little less tight. I am seeing you mention printing at 102% and I hadn't tried that so I'll experiment there but thought I'd send a note. Thanks for the design, regardless!

Hi there - I purchased your hive drawers back in mid 2020. I had fair luck but the interlocking shells have been simply too tight and require sanding and such. I'm looking to know if maybe there was an update to the STL since I see a later updated date on the cult3d page or if you have advice to make this a little less tight. I am seeing you mention printing at 102% and I hadn't tried that so I'll experiment there but thought I'd send a note. Thanks for the design, regardless!

Daniel.  I'm new to 3D. Could you possibly advise roughly how much it might cost to print one of the elements in your  Modular Wine Rack ?
https://cults3d.com/en/3d-model/home/modular-wine-rack-o3d.

I like the asymmetry of the design and suspect it may be both relatively efficient in terms of the amount of material as well as stronger in more than one direction, is that correct?
Many thanks, John

Hello Kai,

Thank you for letting me know. I have added the knob!

Regards,
Dan

Hi,
sorry to disturb but I bought your evo box design because I printed some of your other boxes and wanted to pay back for the effort you spend. But sadly on cult the knob for the evo boxes is missing.
Could you somehow add it?

Thx in advance

Regards,
Kai