Skip to content

Playseat Challenge Logitech shifter mount

Did you 3D print this model?

Maker
3D Model

Make's Description

Made in PLA with Slic3r. Did it with 25% honeycomb infill and slightly increased bottom and top layers.

Position and mounting was very good.

Only drawback.. the closing mechanism of the seat is almost impossible to manipulate now. Perhaps the clamp can be mounted differently. I'll address that later..

3D Printer

Prusa i3 MK3
  • Raft: No
  • Resolution: 0.2 mm
  • Temperature: 215 °C
  • Support: No
  • Infill: 25 %

Related contents


Add a comment

4 comments

awesome. have you fixed or redesign any for the right side hitting the wheel bad lock? is it impossible to lock or just tight?
Great Job

Anyone willing to print this and we could pay for it?

I don't have access to a 3d printer, is there any way you could print one and sell and ship it?