FuRRARI 333SP - 1/24 SCALE KIT

UPDATE: v3!
I now added a 'sprue' of both the common parts and the daytona body parts, so they can be loaded as a pre-supported file on your printer, ready for slicing.

And... the full DAYTONA version has been uploaded as well, which are all the pieces labeled with 'daytona', it's a different body and rear end design as well.

Hope you all enjoy !

UPDATE: v2 !

I've been working to make a full-open model, and now you can get it as well. New updates are also an instruction sheet and some more detailed parts overall, made sturdier for better printing results.

I always loved the look of this Le Mans racer, the 333SP.
And as there were no kits available, I just thought to make it myself.

The challenge for this kit was to make it simple, and easy to build.
I did not want to have too many pieces, but I wanted to have a good level of detail, and ... I wanted an engine!

So this is the model, where the main parts are the body (standard and long-tail version included), as well as an engine, and a variety of rims, and two steering wheels to choose from.

I've tested it a few times and built it myself, it's a quick enjoyable kit.

If you want to go crazy, you could even think about adding seat belts and some wires in the interior to make it even look more realistic.

The only clear parts you might want to add, are the lenses that cover the front light, those could be thermoformed (I included some buckets).

Have a lot of fun!

PS: also included are the parts for the v1 of the kit, in a separate ZIP.

I would suggest printing only in Resin, and at the highest resolution possible. Usually to get great results, I prefer not to print 'flat' but at a high angle (20+ degrees).