FLSUN V400 BELT GAUGE

FLSUN V400 BELT GAUGE is for checking the belt tightness. Usefull tool to check wether your belts are equally adjusted. Scale has a marking for optimal tightness at middle, to the left of the mark "T" stands for too tight and to the right of the mark "L" stands for too loose. When tool is printed let it cool down before using any force to avoid bending or deformations. Lower the extruder to the lowest position (close to bed) and then find a middle point of the belt. Squeese the belts together with your fingers and insert the tool, release the belts from your fingers to take readout. Adjust accordingly.

Disclaimer!
Using this tool is at your own responsibility.

Full speed, 3 bottom and top layers, 3 walls, layer hight 1,5mm, wall thickness 1,2mm (line width 0,4mm), infill 20%, no supports or brim!