Fidget Fidget

Fidget toy that can spin and twist and is very satisfying to play with. This even fits in that small pocket everyone haves that apparently still exists from the stone (pocket watch) days.

This build uses:
Skateboard 608 Bearings: x2
4x8x3mm MR84-2RS 1910R Bearings: x2
5x3mm Neodymium Magnets: x2

Print the following:
Fidget Spinner Body: x2
FingerHold: x2
FingerHold2: x2
Pin: x1
Plug (optional): x2

Instructions:
- Print Parts
- Add plugs into center of shaft
- Super Glue the smaller ball bearings to the shaft, ensure they are pressed on all the way the shaft should be flush with the ball bearing end, BE SURE PLUGS are added before gluing to each end!
- Stack the magnets 2 tall and push them into the same fidget spinner body, be sure to super glue them in
- Insert the shaft into the fidget spinner body and press in all the way add a dab of super glue to the plug to hold it
- Insert shaft into 2nd fidget spinner body and press in both the magnets and bearing, adding superglue into the magnet holes before doing so
- twist and separate a little to add last drop of glue to the 2nd plug