Skip to content
Free 3D print files Writing Aid Cuff, 3Dnm8or
Ec44a3e3 54c9 4691 8dd4 052c6d44b83a

Did you 3D print this model?

Writing Aid Cuff

3D model description

Writing Aid - holds pencil, pen or brush for those needing assistance with grip/opposition/hand strength.

In addition to the print, two small strips of craft foam were were attached with Super Glue. 1) 2mm thick, 1.25" wide x 2" long (trim excess) lines the inside of the finger cuff. 2) 5mm thick, 1" wide x 2" long attached to the bottom of the cuff (as pictured). A Velcro cable strap is attached on the side of the cuff just above the slot. (Amazon - Mediabridge Cable Straps 50-Pack (30 × 15CM, 20 × 25CM))

3D printing settings

Printed with PLA on an XYZ miniMaker
1mm / slow
No raft
No support

  • 3D model format: STL





Similar 3D files

Best sellers of the category Gadget

Add a comment