Up to 18 game cartridges and 4 MicroSD in these ice creams for Nintendo Switch

Meaaaaaaaaaaa!!! These ice creams look so good!

Yes, and they are stuffed with game cartridges for Nintendo Switch. I don't know if it's digestible, but it's very practical and rather unexpected.

They are garnished with hazelnut chips or sugar flakes. Some are intact and others are already started. Depending on the case, you can store 10, 12, 15 or 18 cartridges, as well as 1, 2 or 4 microSD cards.

IMPORTANT: The files you buy are sold under Copyright. This means that they cannot be sold or distributed for free. Additionally, you may not sell prints made from these files. If you did, you would jeopardize the creation of new designs. Thank you for your understanding.
YOU CAN HOWEVER SELL YOUR PRINTS OF MY DESIGNS by subscribing to the "3D print seller" subscription: https://www.patreon.com/LabLabStudio
ALL MY CREATIONS ARE INCLUDED IN THIS SUBSCRIPTION

You can print 8 different ice creams. There are those composed of 2 or 3 faces, and those intact or already started.
Started and 2 faces: 10 cartridges and 1 microSD card
Intact and 2 faces: 12 cartridges and 2 microSD cards
Started and 3 faces: 15 cartridges and 2 microSD cards
Intact and 3 faces: 18 cartridges and 4 microSD cards
And each of these 4 models is garnished either with hazelnut chips or with sugar flakes.

Come on foodies, take your pick...

And to present them properly, there are fairy’s fingers. I added a stand to hold the ice cream upright.

Do not hesitate to post a make, your creations always inspire me.

You can find all my models here: https://cults3d.com/en/users/LabLabStudio/creations

These ice creams are inspired by the original cube:

LabLabStudio

12 in 1 Storage cube for Nintendo Switch game cartridges and MicroSD cards

• 124k views
• 1.1k likes
• 1.4k downloads
• 60 comments
• 12 makes

Download US$2.12

The few necessary supports are integrated into the models. You have nothing to do.
PLA works wonderfully.
Warning: If you print in resin, it will break.