Skip to content

COVID-19 MASK (Easy-to-print, no support, filter required)

?
Make’s quality: 4.5/5 (1 vote)
Evaluation of members on the quality of 3D print, material, post-processing, photo, etc.
Maker
3D Model

Make’s description

Easily scalable took a few hours to print the main mask part used supports to make sure it all printed well at the layer hight i was using, I don't think it would have needed any.
This is a great design , thanks for uploading it. :)

Filament

PLA
  • Raft: No
  • Resolution: 0.35 mm
  • Temperature: 190 ℃
  • Support: Yes
  • Infill: 25 %

Other makes from the same 3D model


Add a comment