All Valley Karate Kid Tournament Trophy

I designed this trophy because I'm a big fan of the Karate Kid movie and the Cobra Kai, so I put a lot of love into it.
To print I used trophy_plate.stl because trophy_plate_all_letters.stl loses a bit of resolution in the letters, I believe that superior printers can print the all letters version without problems. To print Top_fighter.stl I used custom supports, just be careful with the supports near the support foot as they are fragile and removing them could break the piece. I also used supports in the following pieces: Angel.stl, Trophy_Tower_Top.STL (to fill the holes at the bottom).
The colors that should be printed in order to be more faithful to the original trophy are shown in the photos. Only brown and gold PLA was used.
All other parts can be printed as you wish and adapted to your printer.
When all parts are printed just align and glue them with super glue.
ALL DONE Enjoy! :D

. I used the following print settings:

• Creality ender 3 printer and Cura software

• 25% Infill

• Speed 25

• Print with a low layer height for good resolution.