Base feet distancers - Weedo Tina2

Missing files have bin uploaded for large robo feet.

Created to give better airflow to the two engines at the bottom for long prints.
When printed with flashforges gray pla do they look really good on the machine.
made to simply slide in on the case and dont sit to tight to make them easy to remove and put back.
recomend furniture damping pads on there bottom and best in rubber.

Thanks for the support.

Added a bonus distancer.
Simply mirror it in slicer app for each side.
And is some low polly paws.

New bonus is the tall robo feet.

Wanted to be able to store more things under my machine and wanted it to look cool.
so designed this and used about 500 g of pla while prototyping them during a weekend.

I think they are pretty cool now and are very modular where you print inserts in another colors and fully printable on the small machine,
uses less then 100 x and 100 y to work even on older tina2 models.

Hope you like them as much as me ;)

The print will string but use a sharp knife to clean up after print.

the legs them self take about 1.3 h to print.
other parts 6-22 min.

layer 0.2 - 0.4 ( bonus feet 0.1 - 0.3 )
walls 3
top and bottom 3
top bottom thickness 1.2 mm.
print speed 32 - 40 mms
infill 10 - 20 percent ( bonus feet 5 percent )