GUN FUN - BUNDLE - Customizable

THE BUNDLE. Includes standard version, stronger version, tighter version with slit only on one side and bump version.

Better start with a wider version, the sensation is quite strong.

Each can be customised, just scale the "sleeve" file to your liking and add the adapter (the tight version has a slightly different adapter - oneslit_adapter.stl).

The gun will cost you from 15 € (e.g. "Hi5", which works very well for us and is small). We have tested several guns and the inner diameter differs very slightly (see Connectivity, below), it should not affect performance but will affect how tightly the attachment sits in the gun.

Hygiene? Use condom or a disposable glove with some lubricant. Either will also soften the massage if the massage gun is strong.

Connectivity? The Massage Guns seem to be pretty much standardized. The inner diameter of the gun will be approx. 19mm. If you have trouble there is always the possibility to contact us or to just resize the separate adapter a little.

Print Quality Issues? TPU qualities vary (as is true for any type of filament). Make sure you take care when finishing your prints to avoid hurting yourself, and always protect your best asset with a condom.

Disclaimer: The Massage Gun in the picture is only for illustration. It is not part of the design. Use this file and the product at your own risk.

Print in TPU. Settings depend on the quality of your TPU.

Increase infill if your print is too flexible.

Recommendations for a start:

0.2 layers.

2 walls.

10% infill normally sufficient. For less flexibility use more infill.

Raft for bed adhesion.