Miraculous Ladybug keychains set x6

I was looking for keychains from this series, but for some reason I found very few that I didn't like, so I decided to make them myself.

I put together a set of 6 very cute keychains. And most importantly, they CAN BE PRINTED WITH ONLY 1 EXTRUDER. Through the laminator configuration (in this case Cura) I use pause at heigth, and select the layer number in which to pause and change the filament. In the keychain logo tikki, logo plagg, keychain miraculous and dige box miraculous you only have to change the color once to get it right. On the plagg keychain you pause 3 times, one for the body, one for the eyes and the last one for the rim. The tikki keychain is paused 2 times, one for the eyes and the other for the spots and border.

All the key fobs were printed at a speed of 70 mm/s, with a shrinkage of 2 mm, with a shrinkage speed of 25 mm/s. Each key ring is detailed below:

-Key ring tikki: 55x50x4mm. Pause at height: layer 23 (49%), white (eyes), layer 28 (62%) black (spots and border). Time approx. 1 hour.

-Plagg keychain: 55x50x4.5mm. Pause at height:layer 18 (40%) black (body), layer 26 (72%) green (eyes), layer 33 (82%) gray (border). Time approx. 1 hour.

-Miraculous keychain:75x40x4mm. Pause at height: layer 28 (49%) black (border letters). Time approx. 1:10 hour.

-Dige miraculous box: 60x60x4(I recommend 75x60x4mm for details). Pause at height: layer 28 (50%) red (details). Time approx. 1:10 hour.

-Logo tikki:50x50x4mm. Pause at height: layer 28 (68%) black (spots and border). Time approx. 1 hour.

-Logo plagg:50x50x4mm. Pause at height: layer 28 (51%) green (print and border). Time approx. 1 hour.

I RECOMMEND checking all settings on your laminator as depending on any modifications or settings could vary times, layer number, percentage at which to pause, etc.