Xenomorph Pen/Stylus Holder

This is a Xenomorph Pen/Stylus holder I designed as I wanted one for my Wacom and I'm a huge alien fan :)

V3 Update: XenoPenHolder_V3.stl

I fixed some issues:

• The angle of the teeth is now higher which makes them look much better as the don't "drool" down due to lack of supports so they are much sharper and nicer looking.
• I brought some of the side pipes close to the body - With high speeds printing i had issues that made them break/snap during printing so it's now much sturdier.
• Added some minor details.

V2 Update: Xeno_Pen_Holder_V2.stl

I was not fully satisfied with the jaw design in the original version so I basically redesigned it with the following changes:

• The inside is now shaped like a pen so any pen/stylus should fit in nicely and smoother than in the original design.
• Made it look a bit more realistic and added a lot of details (File size is therefore bigger)
• Removed the holes - they look cool but it's not really how the jaw looks.

I think this version looks better and works better - Print this one at 100%

A kind request, Please help supporting the work of all 3D artists!
Do not sell or share digital files bought here and on other sites.
Buying this model DOES NOT allow you to sell physical copies of it, It is for personal use only.

If you want to sell my prints commercially, you can join my Patreon:
https://www.patreon.com/3DGeex

Check out my social media accounts to see what I'm doing next:
https://www.instagram.com/3dgeex
https://www.tiktok.com/@3dgeex
https://youtube.com/@3dgeex

Thanks, Michael - 3DGeex

--------OLD DESCRIPTION-----------------

There are several versions here.
1. Xenomorph with big inner jaw
2. Xenomorph with small inner jaw
3. Xenomorph with no jaw
4. Small jaw
5. Big jaw

I did the versions so you can scale it to the size you want and also have the jaw as close to the size you want without having the actual head too big.

Printing at 100% - The big jaw version will probably work for any stylus/pen as the diameter of the mouth will be about 1.8cm
The small jaw version will have the head same size but the jaw about 1.2cm so much smaller
I also did a version without the jaw - Where you can print and attach the jaw separately (it should fit in nicely)

So basically all these versions are so you can find the right size of the head with the right size for the pen/stylus :)

I think 90% should work the best.

0.1 Layer height will obviously give nicer results but you can also print at 0.2
Infill 10%-20% should be ok.
Use 3 walls so you don't see the infill pattern on the head.
No supports(!) & No brim/raft needed
At 100% it's about 60 grams.

Purchasing this model, DOES NOT allow you to sell the digital file or printed model - Please help support the creative work of each 3D artist!

If you want to sell it please contact me and we will figure something out :)