The Koozie Kaddy

"The Koozie Kaddy"
If you're like me, you have can koozies. A lot of them. I was tired of seeing them loose in a drawer, so I bring you, the Koozie Kaddy. A dispenser for your can koozies. The original model will hold around 18 flattened koozies. by keeping the supports underneath the model, you can set it on a counter or other flat surface. If you wish to hang or mount it, the supports underneath may be removed.
Included in the files, there are a collection of generic models.
- The Original Koozie Kaddy(1" opening)
-American Flag Cutout
-American Flag Cutout with Smiley and Yuengling Logo
-A Version of each model with a smaller opening for flatter koozies(0.75")
-An extension for the collectors among us, which adds another 6" to the total height.
I will likely be adding to this collection as I make more versions. these later versions will be available to anyone who has previously purchased the creation.
If you would like a custom version with your own brand or logos, name, or anything really, please feel free to send me a message and I can make a custom one for you for an additional fee. There are a total of four locations for custom designs: left side, right side, back side, and the dispenser lip(seen pictured with a Yuengling logo).

I recommend a PLA+ or PLA Professional for its strength and durability. Standard PLA will work, but may not last as long.

• use temps recommended for your material/printer.
• 0.2 layer height
• set wall count to 1000 for maximum strength. 100% infill if not.
• supports on/full/everywhere. Do not select "touching buildplate only". This will ensure you have supports in the opening and where the logos or letters are cut out of the side of the dispenser.
• you can keep the supports attached to the bottom of the print to allow the item to sit flat on the counter or remove the supports underneath if you wish to hang it or mount it to the wall.
• print orientation is standing up straight.