Part holder for the black series darksaber

I was sick of keeping the blade and other parts for my darksaber (force fx elite black series) in it's packaging on the floor
So I designed this holder for the blade, hilt end (not sure what else to call it), and the allen key

I've designed it to use zip ties to secure it to whatever you're mounting it to, you could also drill holes in it and screw it to something (didn't put holes in the design as it would create a nightmare for supports)

I wanted to design it to not need supports at all, but I wanted to give it a spot to grip a zip tie as well, and that idea prevailed. I recommend using brim (or raft) if slicing in cura, just to help the supports not get knocked over etc

EDIT: so when I designed this I didn’t think about shrinkage, luckily it’s easy enough to fix. I used an ender 3v3se and esun black PLA, took a little trial and error but my final attempt I scaled it up by 3%, the blade now fits and the stub almost fits, maybe try 4% or 5% (though depending on filament/printer/other variables it may be different for you), the allen key is still a ways off fitting so maybe I measured wrong somehow for it, you could try drilling it out a bit, though it may be too close to the hole for the stub.