Display Stand Set for Dotted Brick Models

I wanted to create a good looking but consistent display stand for my sons various builds. I came up with this set of displays that will hold the model at either a 90° or 45°.

The smaller of the displays stand holds the model at 75mm high, is 45mm at the base, and has a 2x2 dotted brick pattern. When balanced correctly this will hold small to very large models.

For larger models or if you wanted more stability there is a larger display that stands at 80mm high and has a 50mm base. This also has a 4x4 pattern to give even more stability if you so desire.

I also found that since it was hollow, that I could add a little led light puck in the base and use it to set up some pretty dynamic lighting setups.

I hope you are able to use these to display some really amazing setups, no matter what genre of models you may have.

These stands are 45 -50mm square at the base and 75-80 mm high. To print no supports are required and used a .2mm layer height. On my printer it took about 3.5-4 hours to print.