Raspberry PI 3 - PI4 - PI5 Desktop Remix

This is a remix of a Raspberry PI 4 Desktop found at the following address...

https://www.the-diy-life.com/diy-raspberry-pi-4-desktop-case-with-oled-stats-display/

LED display: https://amzn.to/48RUyI9

Optional Ice Cube heatsink: https://amzn.to/4q0OHqH

I added additional vent holes and printable sides without the fan hole.

Instruction for this build are at the address above.

Update: Instruction for the Bullseye raspberry OS are at the following address:

https://www.the-diy-life.com/add-an-oled-stats-display-to-raspberry-pi-os-bullseye/

Update 2: added vents and sd access as well as a body for the PI3

You might need supports in the holes except for the vents if your print does not bridge well.

2024 - UPDATE For the New Raspberry 5 you may use the cases for the PI 3 and side covers for the PI 4... I recommend not using the ice cube heatsink, rather use the Active Cooler for the PI 5... https://amzn.to/49ckSf2

I could not find any instructions for the LED Display and the Bookworm OS. So just print the case with no hole for the display.

License:
Original 3D print design or remix © 2024 by Christian Wilson is licensed under Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International. To view a copy of this license, visit https://creativecommons.org/licenses/by-nc-sa/4.0/

For more information on 3D printing visit - https://3dprinting-source.com/

More of my models - More of my models - https://cults3d.com/en/users/MilVetRetired/3d-models

Tips appreciated: https://paypal.me/christianwilson1386

Please follow to receive new model notifications.

FlashForge Adventurer 5M Pro - https://amzn.to/4rRKAit
.20mm LH
Speed - 420mm/s
infill - 10%
No Supports, rafts or brims required.

Please post your make of this model.