Phone Stand

I've downloaded and printed a few different phone stands, but none of them seemed quite right. A lot of them seemed to be designed for smaller (older) phones, or maybe phones that aren't in cases, with hooks that wrap around the front but won't fit the phones that I have. Some of them just didn't seem stable. In the end, I designed this.

Features:

1) Rough textured surface where the phone sits to prevent it sliding off as easily
2) Hole in the bottom of the shelf so you can plug in a charger while it's sitting in portrait view
3) High back for stability with larger devices
4) Angled appropriately and only a small lip on the front of the shelf to accomodate a wide range of device thicknesses
5) Larger shelf to help accomodate thicker devices, and raised a bit so that charging cords can fit underneath it
6) Cutout on back at top - Probably useless, but I figured on smaller devices it might increase your chances of being able to access things at the back of your phone like buttons, camera, fingerprint reader, etc. Most phones will sit above the top of the back anyhow.
7) Circular cutouts on bottom to add optional TPU feet to prevent it from sliding around
8) Looks sweet! (subjective)

If you liked this design, please post a make!

Phone stand printed lying on its side (it is positioned correctly in the stl) at 0.3 layer height with supports and 15% infill.

Feet were printed (slowly) at 0.2 layer height and 100% infill.