Eraser Head Aizawa Goggles

Because Eraser Head's goggles are here!
Cosplay prop for Aizawa sensei.
Plus ultra!

Made of yellow and black PLA.
Apart from 3D printed parts you'll need elastic strings, and some glue.

Check out my instagram page for more cosplay content.
https://www.instagram.com/laczabetyar_cosplay/
Will shoutout your make in a story if you tag me on IG.

Size of parts
eraser_band.stl X 42 Y 140 Z 1.2 mm
eraser_bridge.stl X 26 Y 8 Z 18 mm
eraser_goggle.stl X 66 Y 45 Z 53 mm
eraser_lens.stl X 73 Y 36 Z 0.5 mm

Recommended slicer settings for each part below.
For orientations see attached slicer screenshots.
Only left side model included for paired parts. Just mirror them in your slicer, to make the symmetrical ones.
Printer Anet ET4

eraser_band.stl

Layer height (mm) 0.18
Shell thickness (mm) 1.6
Bottom/Top thickness (mm) 1.5
Fill Density 10%
Print speed (mm/s) 50
Print temperature (°C) 200
Bed temperature (°C) 70
Support type None
Platform adhesion type None
//I oriented it with the patterned side down. Thus it became smooth shiny because of the glass bed.

eraser_bridge.stl

Layer height (mm) 0.18
Shell thickness (mm) 1.6
Bottom/Top thickness (mm) 1.5
Fill Density 10%
Print speed (mm/s) 50
Print temperature (°C) 200
Bed temperature (°C) 70
Support type Everywhere
Platform adhesion type Raft
//I have not layed flat this part, because the layers would look worse.

eraser_goggle.stl

Layer height (mm) 0.18
Shell thickness (mm) 0.8
Bottom/Top thickness (mm) 1.5
Fill Density 10%
Print speed (mm/s) 50
Print temperature (°C) 200
Bed temperature (°C) 70
Support type Touching buildplate
//The support is very hard to remove even with tools. Always wear safety glasses while removing support, due to flying fragments of plastic!
Platform adhesion type Raft
//I have used raft with this part because very small area touches the buildplate, and the two islands tend to lean before they merge.
//Lay flat.
//File, and sand the goggles carefully, mind that surface which contacts with your skin. Remember, you are going to wear it on your eyes. Do not hurt yourself with the print's rough surface, or remained fragments from the support!

eraser_lens.stl

Layer height (mm) 0.24
Shell thickness (mm) 0.8
Bottom/Top thickness (mm) 0
Fill Density 50% //the net structure is created by infill
Print speed (mm/s) 50
Print temperature (°C) 200
Bed temperature (°C) 70
Support type None
Platform adhesion type None

Assembling
Glue in the bands to the side of the goggles.
Use elastic string to connect the goggles with the bridge.
Also connect the end of the bands with elastic string.
Glue in the lenses if needed. (I just snapped them in.)