Detailed Labyrinth Door Knocker Set

DO NOT BUY
DOES NOT WORK
NO UPDATED VERSION AVAILIBLE
RINGS DO NOT FIT

Very poor design. waste of pla the knockers do not fit and the mouth wont close and there is no way of fixing to a door do not buy.

Modeled poorly. Ring doesnt even come close to fitting and model has to be heavily cut and modified to make it work. I had to remake the entire lower jaw in Fusion360.
Dont waste your time.

I dont understand where to cut the ring for the Ear Head Knocker

The ear knocker will need to be cut after printing to allow it to be slid in each ear.
Knocker rings have to be printed in two parts just glue and hold together with clothes pegs.
Ear mounted knocker will not sit at 90 degrees due to the ears but it will knock. This can be rectified by me adding some stylish knocking pads as see from the movie which I will work on.
Mouth knocker works on my print but I will look at making alterations on this and modelling some knocking pads.

Bought these models and they look good printed but, the rings don't work right.
The ear mount won't knock or lay flush and the mouth mount is not even close, as the ring will not fit and the mouth is not formed to accept a round ring.

I printed scaled down to 50% on a Creality Ender 3 v2 using Cura 4.8.0 to slice at otherwise standard quality settings.
I may attempt to have metal rings made but the mouth will need some kind of pin to at the lips keep a smaller ring from escaping the jaw that is poorly modeled. This set needs work, not happy.

Does these print in 5 different sections and if so how do you get the 2 sides of the ring to stay together when it’s done

Nice design except for the fact that the ring doesn't actually fit into the mouth. I had to cut away parts of the mouth inside so that the ring would fit and allow the mouth to close.

Can you explain where the CUT needs to be made on the 2nd knocker? And do you mean a cut of the 3d model or like a physical cut after the print is made?