HICAPA 5.1 CARBINE KIT

This is a carbine kit designed for the Novritsch SSP1. I will fit any 5.1 HI-Cappers. You can fit almost any stocks.

It's designed in a way so it would never ever break. It looks like a brick, but you don't have to print new parts after every game!

It uses a lot of M4 machine bolts and nuts to lock the whole system together. There are 4 parts that all go together.

It locks the pistol with an M3*42 mm screw and an m3 nut. This locks in under the pistol Picatinny rail. It has been designed to never fall out even if your pistol have a large blownbag. So the slide lock is nothing to worry about. This will never ever break you gun og carbine kit.

You need
9 M4*12 countersunk
4 M4*16 countersunk
1 M3*42 all M3 bolts works.

2 3mm aluminum rods around 10 cm each to prevent bending between the front part and the back part.

You do also need an aluminum piece for the stock so it doesn't break. (See pictures)
Size = diameter = 25 mm
Thickness = 1 mm
Length 205 mm
I found mine from an old picnic table.

Use the file (DrillGuide) to drill holes into the aluminum + 3d printed stock

If you have any questions, write me a mail at: quizendesigns@gmail.com

It printed on the Prusa MK3S

• Support is needed for some parts (depends on your printer)
• 0.3 mm per layer.
• Print in PETG or ABS for best results.

You will need an FDM printer for this.
The total print time is around 22 Hours (on Prusa MK3S)
2-3 Hours of clean-up parts.