Spear Primal

"3D Model ready to print =D, Separated pieces with sockets to facilitate and improve the finish when printing

Any comments or problems you have with the file when printing do not hesitate to write us! your opinion helps us!.

Tips:
In case you are printing in FDM with PLA material and you have calibrated the tolerances you can facilitate the fitting of parts
Applying a little heat with a hair dryer / heat gun in the male joints.
You can also leave the part on the printing bed for 5 to 10 min at 80° so that the material will silk when fitting."

"3D model ready to print =D, Separate pieces with sockets to facilitate and improve the printing

If you have any comments or problems with the file when printing, please do not hesitate to write to us! Your opinion helps us!

Tips:
In case you are printing in FDM with PLA material and you have not calibrated the tolerances, the fitting of pieces can be made easier
by applying a little heat with a hair dryer / heat gun to the male joints.
You can also leave the piece on the printing bed at 80° for about 5 to 10 minutes so that the material softens when fitting."

Recommendations
- Layer Height: 0.24
- Infill: 5% - 8%
- 2 Wall Lines (3 if you want more resistance)
- Activate Tree Supports for better finish (Depending on your machine between 60° and 75°)
- Activate Support Interface to improve Support-Part adhesion
- Activate Edge to improve part to bed adhesion

But feel free to experiment with different configurations to achieve the finish you want!

"Recommendations
- Layer Height: 0.24
- Infill: 5% - 8%
- 2 Wall Lines (3 if you want more resistance)
- Activate Tree Supports for a better finish (Depending on your machine between 60° and 75°)
- Activate Support Interface to improve Support-Piece adhesion
- Activate Edge to improve the adhesion of the piece to the bed

But feel free to experiment with different settings to achieve the finish you want!"