RC 3-sided tipper for 1/14 truck

RC 3 side tipper. The tipper can open the left-hand side wall using an actuator. The rear flap is opened using N30 geared motors and the right-hand side wall is opened at the bottom using a servo or optionally at the top using N20 geared motors. The model is for experienced model builders. Truck undercarriage is not included as a file. The axles and rims were sourced from SHAPRAS, the MAN driver's cab from Gusrsta9982 and the mudguards from norbertkok.

Functions can be viewed at this link https://youtu.be/QB1vMWmdCyY?si=80LVMOweuCqRRGhJ https://youtu.be/-uEIN5gPiQs?si=vxHcKQxBFfLNkjBa

Purchase includes blueprint, parts list of non-printed parts and list of tipper pressure settings.

The tipper is built on aluminum U-profiles. However, the beams can also be placed on other frames with a little modification (simple modification in TINKERCAD).

This is required:

• 2 x controller small

• 1 x controller large

• 1 x linear actuator 50mm

• 2, 4mm brass tube

• 2 x N20 and 1 x N30 geared motor

• M3 -M5 fusion nuts and screws

The dimensions of the tipper: 38cm long; 20.5cm wide; 15cm high; the side walls are 6.5cm high and the rear walls are 4cm high.

Installation space size 220x220 (my printer Bambulab P1S)

Material PETG or PLA

• 20 to 100% infill

• 6 walls

• Support only if necessary