NadaYak 560mm 2S or 3S RC Airplane

This is a 3D printed RC plane than can be flown on (2) 500mah tiny whoop lipo batteries, a standard 2306 19,000kv drone motor, 3 9g servos and a small 15A ESC. You will need (2) M2 x 12mm and 3 M2x8mm bolts and 5 M2 nuts (optional, if not, just glue everything).

The plane flies great on 3S as well, I used (3) 380mah lipo batteries connected in series.

It can be printed in either PLA or LW PLA
The target for this build was for new pilots who want to explore 3D printed planes without having to buy a lot of new equipment or figure out how to print with LW PLA.
The parts are broken down small enough to print on a 220x220x250mm bed plate.
CG is about 45mm aft of the leading edge of the wing (right where the aileron pushrod holes are).

Flight Video:
https://youtu.be/CsGQHu8883I?si=WAauS3I34_oCdXhu
Build Video:
https://youtu.be/pdPXlb6B6w4?si=IIfbrIphiqhkbn-5

I have a Creality K1 Max and use Creality Print slicer.
For both PLA and LW PLA I use:
1 Wall
3 top and bottom layers
2% Cubic infill

For the motor mount, control horns, hinge material, battery mount, and hinge spacer. I use the default PLA settings. (print these parts in PLA if you are doing a LW PLA build.