1/24th scale Sequential Stick Shifters, 6 different designs

Update: I just added a 6th design, a shift stick inspired by the handle of a katana. In case you could use something like that for your next project.

I have made a set of 6 different Sequential Stick Shifters (11 files in total), that works really well with most plastic models.

The base plate of the Sequential Stick Shifter is 3.7x9.2 mm, it should fit in the mitter console of most model cars. But make sure to check if it fits in your model car before purchase.

These models are not suitable for downscaling.
I have included a few alternatives to V3, to make sure that it will print correctly on lower resolution printers.
For V4 I have added a left and right version, so that you can choose what ever version you think fits your model best.
For V6 I have added a few different versions, so that you can have it straight up and down, or offset on the center axis, so that you can choose the version that fits your project best.
Make sure you check out the photos to see the different versions, that comes in this bundle.

If you need some other sizes feel free to message me, and I will see what I can do.

Feel free to go and check out my profile for more printable stuff for your model cars and scale dioramas.

Disclaimer:
- Resale of the files is NOT allowed
- Printing for commercial use is NOT allowed
If you have any questions, please contact me here on Cults3D.

Recommended printing on a resin printer, at layer eights around 0.02-0.01mm for det best results.
These have been test printed at 0.02mm and on a 4K, 6K and 12K resin printer, with great success. The higher screen resolution is needed to ensure the best result. These connectors are so small that a lover resolutions screen might yield you some bad results.