Fegefeuer Dämonen Rahmen

A nightmarish, infernal picture frame.
Perfect for dark fantasy décor, gothic galleries, haunted displays, necromancer lairs, or as a standout prop on themed bookshelves.

📏 Measuring Instructions (Cosplay / Display)

This frame is designed for wall display or book cover decor, but can be resized for any print setup.

Frame Fit

Measure your photo, print, or insert:

Width – measure the horizontal span of your print

Height – measure the vertical span
Scale the model uniformly until the inner opening matches your desired fit.

Object Mounting

If you plan to use it as a prop stand or wall piece:

Add 2–4 mm tolerance if inserting plexiglass or cardboard

For LED backlighting, leave 5–8 mm spacing behind the opening

For wall mounting, scale depth based on the weight of the insert material

🛠 Printing Instructions

Layer height: 0.16–0.28 mm

Supports: Recommended — many deep cavities and horns

Orientation: Print flat on the back for best adhesion

Material: PLA+ or resin for maximum detail

Infill: 10–20% is sufficient unless scaling very large

For massive wall-size prints, use a low-heat gun or hairdryer to fine-tune any warping on the outer tendrils.

🎨 Finishing Tips

Start sanding with 120 → 220 → 400

Apply a dark primer to emphasize sculpted depth

Dry-brush bone, ash-gray, bronze, or infernal red highlights

Wash recesses with black or sepia to bring out the screaming faces

Metallic rub-on pigments give the horns a scorched metal look

LED backlighting creates a dramatic glow behind the demonic silhouettes

A hairdryer (or heat gun on low) can gently adjust the thinner horn tips if needed.