Hi there, what are the chances you can adjust the size of the design - https://cults3d.com/en/3d-model/game/sweetheart-storm-airsoft-modular-battery-stock - to fit a 31mm x 35mm x 85mm battery? 😊
- 0 мне нравится
👋 Всем привет! Эта тема является публичной, поэтому давайте будем вести себя вежливо и уважительно. Никакой рекламы, спама или гадостей!
🇨🇳 Страна пользователя: Китай
🌐 Предпочитаемый язык пользователя: Английский. Вы можете переводить онлайн через DeepL.
💡 Вы имеете в виду конкретную модель? Добавьте ссылку, название или номер модели.
🖼️ Хотите разместить фотографии? Используйте бесплатный хостинг типа ImgBB и вставляйте ссылки в сообщение.
✍️ Советы по написанию**: Используйте формат Markdown, чтобы структурировать текст и сделать его более читаемым.
Напишите ваше сообщение:
4 комментария
Hi there, could you share your recommendations for print orientation? I'm trying to print the storm file that I bought from you but it seems a little bit difficult to print. What kind of supports did you use?
- 0 мне нравится
It is recommended to use HP's nylon powder sintering technology for printing this design, this services can be found on some e-commerce platforms.（In China, using this service to print a main body tailstock would approximately cost about 300 RMB.）
It is not recommended to use FDM printing for the main body, as the support for overhanging surfaces will be very difficult to remove. （If you are unable to find nylon sintering services, you can try using slim-tree supports to print this project. In this case, it is recommended to use PLA material to achieve the best overhang effect.If water-soluble support material is used, or PETG material is used as a support for PLA, better quality will be achieved. However, please remember that nylon sintering technology is always the preferred option for this project.）
Neither is it recommended to use photopolymerization technology for printing, as it may cause some tolerances, leading to difficulties in fitting the battery box into the main body.
The box for installing the battery can be printed using FDM, with a material of PLA+. It is recommended to print with the switch hole facing upwards, which will result in good exterior surface quality and less need for support.
- 0 мне нравится
Hi! I'm excited to share my creative models and ideas with all of you. I hope that my designs can bring joy and inspiration to everyone who sees them. I'm open to discussions and collaborations, so feel free to reach out and let's exchange thoughts and ideas. Let's connect and create something amazing together!
- 0 мне нравится
Hi, just bought your SWEETHEART STORM AIRSOFT MODULAR BATTERY STOCK. Just wondering if your design only works with 3s Lipo? I'm running the Sweetheart Storm 2.0 Plus and is recommended to use a 4s Lipo. I could not fit the charging wire with 5 pins. Looks like it was design just for 4 pins. Do you have a design for 4s Lipo?