Вращающееся крепление для экрана Ender-3 V3 KE/SE (Nebula Pad Holder)

Check out our new Rotating Nebula Pad LCD Mount for the Ender-3 V3 KE, SE, and CR10-SE 3d printers!

This mount lets the screen swing along the side to reduce space taken up by the printer. Attaches on the side of the printer to make room for other mods, such as side drawers, storage bins, and camera mounts.

Easy to print and install! Prints entirely in place with no required assembly. Pegs slide up into the back of the Nebula pad and should click firmly into place. Use the stock bolts to attach the mount onto the side of the printer in the usual location and plug the wires into the back of the Nebula Pad. Locks into place at the front and side of the printer by sliding down on the inner hinge.

Supports required for the pegs that go into the back of the Nebula Pad. Due to differences in print tolerances, 3 versions have been included with different peg diameters. The pegs should click firmly into place in the back of the Nebula pad. The standard size is 5.20mm and should work with most filaments/printers. If they are too big and won't slide fully into place, use the loose 5.00mm pegs. If they are too small and won't stay in place, us the tight 5.40mm pegs. Results may vary between settings and filaments.

Thanks for taking a look! Head over to my page and follow for other useful mods and cool prints!

Printed on an Ender-3 V3 SE:
Layer Quality: 0.20mm
Temp: 60C bed, 195C nozzle
Speed: 180 mm/sec
Infill: Concentric, 30%
Supports: Lines, 25% density, everywhere
Wall Line Count: 2
Top/Bottom Layers: 4/4
Brim: Skirt