Biqu H2 VS2 Revo, MAD-MAX Мультивентиляторная поддержка (экструдерная вентиляция 4010, послойная вентиляция 5015, 7515, 7525) Ender 6

I am sharing a bracket/anchor for the BIQU H2 VS2 Revo extruder, ready to be installed on Ender 6.

You can use various sizes of layer fans, and even easily add other models, reaching 7525 and even 7530 that provide excellent airflow for PLA. In addition to all this, there is the possibility of interchanging various outlet manifolds that allow you to further adapt the layer fan to the job and material.

The maximum available printing space 265x275, with this we will reach maximum parts of 381mm diagonally.

With the incorporation of the support everything is fixed and protected, the length of cables and chain is reduced to 19 links, facilitates proper heat ventilation, facilitates access and handling of components and offers excellent results in both technical and PLA.

Air manifold replacement takes less than 1 minute, just remove two screws on the sides and replace.

The fan replacement is done in 2 minutes, by loosening the 4 screws on the bracket and replacing it with another one. The standard Ender 6 board can work directly with various fan models up to 7530, thanks to the excellent Mosfet and power supply it was equipped with, it does not need any change or supplement in electronics.

If you have a BIQU H2 VS2 Revo, this is the support you need, you will be able to get the most out of this magnificent extruder.

If you have a BIQU H2 VS2 and you want to install this support, you will only need a small manual adjustment in a couple of screws, you can do it by filing 1mm in the two holes of the anchor or check and tell me the exact change and I will send you the .stl of the part 10 with the change as you need.

The joints are made using M3 thread inserts.

At the moment I include two air manifolds which give very good results:

61-Collector A: PLA is its strong point, although it can be used with good results also in ASA.

61-Collector B: ABS and ASA is its strong point, I know some of you will tell me that in ABS not to use the fan, well try this one, only between 16 and 20%, it will allow you to make pieces in ABS that before it was a nuisance to see how they deformed. As for hardness of parts I have not noticed anything strange, as for the finish is better in difficult parts and normal in the rest.

Also attached is Z axis support suitable for the surface enlargement that will be available, and equally you will need to adjust the X axis, you can do this using the adapter https://cults3d.com/en/3d-model/tool/ender-6-ampliacion-eje-y-con-soporte-ss-5gl that is posted in my profile.

I also include the Creality Sonic Pad sensor mount.

I've had it in use for some time now and I think the time has come for others to enjoy it as well.

Published: https://cults3d.com/es/usuarios/alfmar/modelos-3d

05/06/2024 Extra file added

Perimeters, up and down to 4 or more, density 50%.

Flux between 90 and 95%

Can be printed on PLA but better on ABS or ASA