1-5/8-дюймовый отрезной станок для гибки оправок

This listing is for the 1-5/8 Inch mandrel bend cutting jig, it is used for holding madrel bent tubing while cutting it down, the two pieces interlock with two 10mm pins, this keeps the two sides of the jig aligned.

There are holes at various common angles which will accept a piece of 1.6mm tungsten or filler wire, or using an angle finder/inclinometer the tube can be adjusted and then clamped in the jig and cut down to the desired engle.

Cut Angle Markers to be added.
Or the cut angle markers which have been included can be used to mark the pipe in 5 or 9 degree increments then placed in the cutting jig to hold it while it is cut down.

Please see below link for more information on the cut angle markers:
https://cults3d.com/en/3d-model/tool/tubing-bend-angle-cut-guide-pack

Included in the kit:
1-5/8 Inch - 1D, 1.5D

Commercial License available via a tier 1 membership on Patreon: patreon.com/RKDesigns_

Any material can be used but materials with a hiher temperature rating would be better, especially for prolonged use

Print models in orientation they are already in

Atleast 4 walls and 25% infill