Airsoft M4 PDW Stock Honey Badger Style

Update: 11/6/2024
- Add a more traditional Rifle butt version for those who don't want to print the brace style end.
- Also added a version for DIY rails.

Update: 10/22/2024
- Updated Stock Body and Stock rail cutouts so that it can easily take 15x5mm bar stock. This should help making those who want to DIY the stock from scratch.

This model is a package set of components designed to allow the user to either transplant the parts from a Double Eagle/Matrix Calico Jack stock or print entirely from scratch barring a few hardware components.

I recommend printing this out of durable material. PLA+ at the minimum.

If building from scratch, you will need:
- 3x m2 screws about 5-8mm in length (for the end cap, and spring holder)
- 2x m3 screws about 5mm in length for the rails.
- 2x springs with an approximate OD of 4.85mm, ID of 3.50mm and length of 25mm (this is for the latches)
- 1x spring with an approximate OD of 6.35mm, ID of 4.95mm, and14.50mm in length (this is for the pusher inside of the end cap, not strictly necessary.)
- 15x5mm bar stock. (you can acquire this from McMasterCarr)

This model is compatible with TM-Spec M4s and KWA 2.5 gearbox M4s. You will need to adjust the screw for your buffer tube retaining washer accordingly. (buffer tube washer model not included and not recommended, use a metal one.)

Additionally, there is a .STEP file of the stock rails in the event the user wishes to commission the bars from a third party out of metal.

Note: while it is possible to print the rails out of plastic and the model will still work, it is unadvised. Either source from the Matrix stock or DIY your own. There are measurement specifics in the packaged instructions.

Included in the model is a set of assembly and printing instructions for your convenience.