AEG Battery Grip для PTS Grips

This download includes:
-Battery Grip Base
-Battery Tube Threaded Insert
-Battery Tube End Cap

This grip allows you to run a battery in a carbon fiber tube as the base of your AEG airsoft grip. This grip is made specifically for PTS Ehandced Polymer Grip (EPG) style grips.

NO SOLDERING REQUIRED! This design allows you to fully install your grip without any soldering.

NO GRINDING REQUIRED! By removing the tabs from your Deans style connector and running them through this grip base, you don't have to Dremel out the top of your grip to make your Deans connector fit.

EXTREMELY STRONG! This was designed to take a beating. The sturdy design won't break during extreme use.

HARDWARE NEEDED: All you need is two M3x25 hex screws and one 50mm OD x 47mm ID carbon fiber tube.

Here is the link for some M3x25 screws: M3x25 Screw Set

Here is the link for the 57mm OD x 47mm ID carbon fiber tube: 57mm OD x 47mm ID Carbon Fiber Tube

INSTALLATION INSTRUCTIONS: To install, remove your buffer tube and re-route your battery wires into your grip. If you have a Deans style connector, YOU MUST REMOVE THE METAL TABS FROM THE RED DEANS CONNECTOR. This allows you to install without having to solder. Route your wires into your grip through the motor wire holes. Install your motor, and run your battery wires through the base plate and also through the grip base. Use your M3x25 hex screws to install your base plate and grip base.

To install the threaded insert and end cap, simply super glue them into your 50mm OD x 47mm ID carbon fiber tube. Once dried, the tube can be screwed on and off.

ALL DoWork3D designs are protected by Copyright Law. When you purchase, you do NOT have the right to sell any digital file or printed model of my designs without my explicit written consent.

To legally sell them, you may obtain my permission by contacting me through my profile or sending me an email at doworkdavidblurton@gmail.com. I usually respond within 24 hours.

Please help support the creative work of each 3D designer and NEVER share or sell a digital file.

100% Infill recommended
Supports on
For maximum strength, print with the flat part on the front touching the base plate