TOTEM - модульный шкаф для хранения

To put some order on my desk, I designed this modular TOTEM: phone charger, compartments for all the invading "stuff", something to store tools or pens, put a flower pot...

The construction is simple: the trunk is a simple piece of curtain rod that can be found everywhere (Ø 35 mm) that you have to cut (be careful with your fingers!) to the desired length according to the number of modules you want to put (30 cm on the pictures, but you can do bigger). Some wood screws and a little patience to print everything.

Each module can rotate thanks to the magic of 3D printing! There is a play of 0.35 mm. in the hinge: make sure your printer is accurate enough.

A small screw is needed to fix the module at the desired height.

I use it on my desk, but free to find your composition: storage of your 3D printer tools, jewelry, herbs...

Each component is printable on a Ø 180 mm tray like the NEVA, or on any printer with a tray of this size.

No support ;-)

Average filling 15 / 20 %.

I can provide STEP or IGES files for those who want to make adaptations.

A little "LIKE" if you like this project.

Good print!

#FIVERRCULTS

Layer : 0,2 mm or less if you are patient

No support

15 to 20 % infill