RC F22 Raptor EDF 64mm and the new version (twin 40mm)

UPDATE! anyone who purchased the 64mm version gets the new twin 40mm version as well. Enjoy!

615g all up weight with 1000g of thrust

Twin 40mm Version
2x Xfly 40mm fans https://a.co/d/hzCiq2j
2x 20 amp ESC's https://a.co/d/3BpsXAM
2x 9g servos https://a.co/d/0DU5ULt
hot glue
ca glue
velcro
2x 10mm magnets

Like all my jets, this one is no different. Its super easy to print, build, hand launch and fly. 1100g all up flying weight with a 2200 4S. This F22 uses full flying tails only! I provide two sets of wings. You can build the full flying tails only or use the aileron included wings and run 4 servos. Totally up to you.

things you need
-64mm EDF and ESC
-2200 4S or anything close in weight 1500-2600 should be fine.
-2 or 4 9G metal gear servos. you can run 17g servos for the tails if you like. I haven't tried fitting them but it shouldn't be difficult to shave the slot open for them.
-3x 12" servo extensions
-CA glue
-velcro
-12mm magnets and 8mm magnets
-6mm carbon tube for the full flying tails. I provide a printable FF tail rod you can either print it really strong or use it as a template to cut the carbon tube.
flight video:
https://youtu.be/Fctp4fCqvXc?si=neyLbxiyfs-Q-OYF

I would print this is LW foaming PLA
1 top , 1 bottom and 1 wall
-2.5 % infill for the nose, fuse 1 and canopy
-3% infill for the other fuse parts
-3% for the wings
-PLA 4% for the tailerons aka full flying tails. NO SUPPORTS FOR THE FF tail it will print the tube inside fine