阿恩格斯特灯塔 - N (160) 比例地标模型

The Arngast lighthouse is a 36.27m (119ft) tall lighthouse located in the Jade Bight, German Jadebusen, on the North Sea. It is one of the most popular and recognizable of the German Coast.

The lighthouse stands on a sand bank 4.5km southeast of Wilhelmshaven. Built in between 1909 and 1910 the construction began with the insertion of a total of 112 wood pilons for the foundation that supports the conical tower. It is made with steel and has 8.5m diameter raising 36.27m (119ft) over the low tide mark.

The Arngast lighthouse has two different lantern rooms showing different range of flashing interval and light colour white /green /red to help orientate inside the bay.

Sailing journeys to visit the bay and around the lighthouse can be booked from Wilhelmshaven. Visit Wilhelsmhaven Touristik

The model was designed using pictures and detailed drawing of the actual building in scale 1/160 (N scale).

You can resize it using your favourite software before print, however, if you do so, some of the parts may lose stability or look over scaled.

Model has 25 different pieces that you need to assembly as any other model kit: I attached an instruction booklet together with the downloaded files.

To complete the model you will need too wood dowel Ø3mm to simulate the pier pylons and cosntruction paper 0.5mm thick to build the upper catwalk: With the download you'll get printable template and, if you have acces to a laser cutter, SVG file to cut it.

Printing, painting and weathering will give a lot of fun.

This model can be a great addition to your layout or diorama.

Happy modelling!

• Designed to be printed using SLA
• L70 X W82 X H228 (mm)
• The widest part measure 70x73,4 mm: Check your 3dprinter build volume
• The kit has 25 parts: With the download you get both with and without supports.
• Two versions of the dome are provided: Both with and without railing attached. The modeller should choose which version to print according to his/her techniques and preferences.
• Pier pylons are not provided. I consider easier to get better results using wood dowel Ø3mm
• Upper catwalk is not provided. You can make it using 0,5mm construction paper: A template is provided as well as the SVG file to use it if you have acces to a laser cutter.
• The supported files are not with the optimal printing orientation but with the optimal orientation according to minimize sanding and provided a perfect fit between parts. However, you can add supports according to your methods.
• The kit part T1 LAMP and T2 LAMP correspond to the lamps and has to be printed in clear resin.
• The kit has been designed to allow space for wiring in case you want to lighten with micro LEDs

My printing parameters:
-ANYCUBIC PHOTON MONO X
-Resin ELEGOO standard grey
-Layer height 0.050
-Exposure 1.9 s
-Bottom layer count 6 /25s

Happy modelling!