G1 Throttlebot 变形金刚的轮胎和轮毂罩

Replacement wheels for all Throttlebots, optimised for FDM and easy assembly. Press the hubcap into the tire and over the 1.2 mm metal axle, and you're done! No glue needed.

Additionally includes 1:1 replica models of the original toy parts if e.g. you want to print a new tire in flexible TPU that fits on the original hubcap.

Fits all Transformer Throttlebots: Goldbug, Chase, Freeway, Searchlight, Rollbar, and Wideload.

Layer height 0.1
3 walls
printing order: outside to inside
top/bottom pattern concentric
infill 10% grid
print speed 10mm/s
fan speed 50%
5mm brim for the hubcap, no brim for the tire
no ironing
no supports

To assemble the wheel, push the hubcap into the hole in the tire, then push it over the car's axle pin. This will make the connector slightly expand and keep everything tight.

If your print is too loose, you can also use a soldering iron to heat up the tip of the metal axle for 30 seconds, and then press the plastic wheel over it. Repeat 3 times if necessary, but don't overdo it, because everything else attached to the axle can also melt.