适用于 WE Hi-Capa 的气枪 "STI Eagle 6.0 "滑块

For any of the Residual Evil Fans out there this one was made for you. As a big Residual Evil Fan myself and an Airsoft player I've collected a few pistols from the game.

However one Pistol was always out of my reach, after much searching and disapointment I could find one to purchase so I set out to re-create it myself.
I have made two versions of the slide that fit WE Hi-Capa pistols. I used WE Hi Capa T-rex and I-Rex pistols for the slides internals as these where the only suitable 6" frames I could find.

I have also included the two versions scope rail mount designed and created so you can add you own scope.

You can watch the projects journey here:
https://youtube.com/playlist?list=PLfdY3gh9sYnDKhOE6A_ugoQ8fP2miHyqV&si=sb3Z_HKlm8EhPkLH

If you want to go straight to the installation and fitting guide you can go to the video here:

https://youtu.be/ozIKtmGvHf4

The slides themselves were originally based on:
WE Hi Capa 5.1 Slide Trial Version - https://www.thingiverse.com/thing:3818208
Created by - rosmaziha - https://www.thingiverse.com/rosmaziha/designs
It took along time to get the dimetions and fitting correct as the orginal model did not work with any Hi-cap internals.

The other parts you need will be in a seperate download on this site and will include:
- Front and Rear sights
- Guide Rod Plug
- Short stroke buffer
- Eagle 6.0 Hi-Capa Stands
https://cults3d.com/en/3d-model/game/airsoft-sti-eagle-6-0-slide-accessory-pack

I've been testing and using these pistols at my local airsoft site and I have had an absolute blast, so far I've had no issues with them. Note I have only bee using them with Gas Mags and not HPA.

I have printed and test slides in PLA under the following settings using a Bambu Labs P1S printer:

• 0.20mm Strength @BBLX1C
• Sparse inflin Density ( 60% minium - 80% maximum )
• Support , tree auto , deselect remove small over hangs.

I have included both .STL and .3MF files. I have used both file and they have printed with no issues. If you use the .3MF file I would recommed you 'mesh the boolean' before printing for best results.

As with any 3D printing there can be some tolerance diffrences between prints and printers, hopefully you will not come against any issues but my installation guide covers any potential fitting issues and adjustments you may need to make.