Flexi tyrannosaurus rex

If you want to subscribe or obtain a commercial license, visit my Patreon!
Check out the link for more information:
https://www.patreon.com/PrintyPlay

If you like these designs, check out all my models: https://cults3d.com/es/usuarios/PrintyPlay/modelos-3d

Hello, today I am very happy to present my Tyrannosaurus rex. I wanted to make a friendly and beautiful model. When I was a child I always really liked this dinosaur, I put a lot of dedication into making an excellent model.The model also includes a pre-painted version for bambulab.

This Tyrannosaurus rex has an articulated tail, as well as the head and jaw, and the little arms are poseable. This Design is printed in parts and then joined together to form the model.

To assemble the parts it is necessary to clean any thread or dirt generated by the printing, then you can insert the pieces very carefully by pressing and turning (it is important to introduce it by turning, this will allow you to clean the joints and it will fit more easily) the same time until the piece finally fits into position, once the piece fits it will be very difficult to disassemble the model, except for the arms, which can be removed. IMPORTANT Make sure to remove the little supports, located over the spheres before assembly.

We want to make sure you have the best possible experience with your 3D printer. While we are here to help you, it is important to keep in mind that each user is responsible for the setup of their printer. We are always happy to provide assistance, but please note that we cannot be held responsible for possible errors in the setup that may affect the quality of the print. We are excited to see your creations and are available for any questions you may have during the process!

I recommend printing with 3 layers and with a minimum height of 0.2 mm per layer. If it does not have good adhesion I recommend using outer brim, however if it does have good adhesion it is not necessary.

Very carefully remove the head and to open the model's jaw, release the small locks located on the neck. To assemble the model you must clean the impurities generated by the printing, then you must assemble the model by pressing and rotating the pieces until they fit into place. It is important to know that once you place the tail, head and legs you will not be able to remove them. If you want to enjoy the best result i recomend not to escalate negatively the model, it has the perfect size,but you can scalate positively.