Beat PP1 - Factory Wing Risers

Celica GT4 style wing risers for the factory wing on the Beat PP1.

Have you ever thought that the factory wing on the Beat looked a bit wimpy? Are you a massive ricer? Then I have the solution for you, the Antics Garage factory wing risers.

These mount using the factory bolt holes and allow you to retain the use of the third brake light.
To mount them you will need 4 x M6x20mm bolts and 4 x M6 flange nuts.

Assembly is as follows:
- Print the risers (I used ASA, but ABS or PETG should be fine if painted)
- Sand or fill all mating surfaces flat
- Insert M6 bolts into hex shaped holes in the top of the risers (I glued mine in to stop them wobbling about)
- Remove the factory spoiler (put some tape around the boot lid or you may end up scratching it)
- Attach the risers to the bottom of the spoiler using the flange nuts (they can be a bit fiddly if you have larger fingers)
- Place spoiler with risers into the factory holes of the bootlid
- Affix with the factory hardware
If you have any questions feel free to message me

3D print using ABS, ASA, or PETG
- 4 walls
- 25% infill (gyroid)