Water Diverter for bathroom tap

Note Updated version as of 22nd Jan 2016:
http://www.thingiverse.com/thing:1285270
I have been busy creating the next generation diverter.

Inspired by a couple of these devices seen on Thingiverse.

http://www.thingiverse.com/thing:964637

http://www.thingiverse.com/thing:26844

This one fits a tap aerator with a diameter of 23.5mm.

What makes this different is the annular manifold at the top which helps prevent the aerator choking and keeps it working smoothly to allow a steady aerated stream.

Simply placing your finger over the bottom opening gives nice bubbler style water flow from the top to rinse your mouth or drink.

UPD: I printed another in clear ABS, needed to increase the scale by 2% in the printer software, would have been better 3% in hind sight.

The Silver version was made in PLA, I think items that are going to be in contact with water are better in ABS. PLA can slowly dissolve while PLA is safe I do not know what the colouring agent is, that might leach out and cause a problem, clear ABS should be fine.

I printed this in PLA with standard setting of 3 layers top, bottom and perimeter. I used a 60% fill and it worked fine.

I do have concerns about PLA being in contact with water and I will make this in ABS in the near future.