Ladybug Suncatcher Window Garden Decor Multiple Pieces STL Files

The sun is shining and we're adding to our Stained-Glass Series with this beautiful Ladybug Suncatcher. It's super easy to print, adding a burst of color to any garden or window decor.

The Lady Bug Sun Catcher is double-sided with a separate inner section that prints ultra-thin. When sunlight hits the design, it illuminates with a shimmering translucence that mimics real stained glass (but is far less breakable!)

The 3d printable suncatcher comes in three pieces that are easy to assemble. The Bottom (Black) has recessed areas that the Middle (Red) drop into. Glue the Top (Black) over that, add a chain or string, hang it in your garden or window, and enjoy!

ASSEMBLY INSTRUCTIONS
There are a total of 3 STL files in the ZIP folder. Note the "WHOLE" file is just for display on Cults3D, and is not meant for printing. See the images above for basic visual instructions.

The file names are as follows. Note that the colors are just suggestions based on what I used, and to help you know what goes where based on the assembly photo provided (see images above).

• LadyBug SunCatcher - Top (Black)
• LadyBug SunCatcher - Bottom (Black)
• LadyBug SunCatcher - Middle (Red)

The Middle piece has been carefully rendered to fit perfectly into the recessed areas of the "Bottom" section. It is ultra-thin and should only print 2-layers thick (at 0.12 Layer Height). This is important to ensure a translucent print, and that light is able to illuminate softly through the other side. I also encourage printing in "Silk" filaments. They are less translucent, but the shine is fantastic.

Once you have the inside piece lined up in the Bottom, use tiny dots of glue to secure it in place.

Finally, add glue to the underside of the Top section. Then line it up over the Bottom and gently press them together. Make sure it lines up straight, then use clips or clothes pins to hold the pieces together until it dries.

To hang it, you can use string, wire, or even a suction cup. I like to use a jewelry chain and a small keyring to hang our suncatchers on shepherd hooks in the garden.

Enjoy!

DIMENSIONS
Fully assembled, the stained-glass Ladybug Sun Catcher springtime decoration measures:

X = 13.0cm / 5.1in
Y = 19.2cm / 7.6in
Z = 0.3cm / 0.12in

If you like the LadyBug SunCatcher, be sure to check out other pieces in the Stained Glass Series:

• Playful Kitten
• Dragonfly
• Butterfly
• Hummingbird
• Cardinal
• Tulip Heart
• Wings of Love Angel Heart
• Tribal Dream Catcher
• Sunflower
• Frog
• DMB Flame Dancer
• Foo Fighter FanArt

TOP & BOTTOM
These sections will print well under basic settings.

Layer Quality: 0.2
Infill: 15%
Speed: 60mm/s
Supports: No
Plate Adhesion: None

MIDDLE PIECE
This piece must print very thin to remain slightly translucent. It is only 0.24mm thick. Use the following settings to ensure it prints in just two layers.

Layer Quality: 0.12
Initial Layer: 0.12
Infill: 100%
Speed: 40mm/s
Supports: No
Plate Adhesion: None

Tip: If you're having trouble printing these smoothly, try using Bambu Studio's or Cura's 'Enable Ironing' setting. It takes a little longer to print, but the nozzle will go back over the top layer to smooth it out, just like you would iron clothing to remove wrinkles.