Popla Popper for fishing adventures

I decided to try to print the Popla Popper using ePLA LW material since it floats at any filling parameter. In this way you can adjust the weight of the printed part, which is an important parameter for a fisherman. When using white printing material, you can paint your Popla Popper based on your imagination or the characteristics of the reservoir. If you need a different size, leave your request in the comments and I will adjust the model to your request.

• Material filament eSUN ePLA-LW
• Printer model Kingroon KP3S
• Software PrusaSlicer 2.8.0
• Popla Popper Size 32 x 20 ( max weight 3.5g) , 32x22 (max weight 4.8 g)

• Printing time about 44 min - 50 min

      When the printing process is finished , take 2mm drill and manually drill through the hole to remove the print overflow. The drill diameter (2mm) should be 0.2 -0.3 mm smaller than the wire diameter ( description of the wire part follows bellow) multiplied by two.  For the final preparing use stainless steel wire d 0.8 mm to make the holder according to the downloaded picture.
     The are two versions available for download - on with front side at an angle of 90 degrees to the horizon, the second version has angle 10 degrees to the horizon. For good quality you should use project file . You can change the data in Filament setting - Extrusion multiplier from 0.4 -0.6 to change the weight of Popla Popper - 2.5 g till 4.5 g . 
  

  Case for Popla Popper have to print PLA material according to the projeсt file .