Z-наклон с помощью макроса ручки + модели для Comgrow T300

I followed the instructions, using a 10mm brim on the knob. It printed perfect.

The macro is all go! It worked perfectly. Without touching anything, I rant the z-tilt-cal macro then went right to my reference DISK print. I have to say this is the first time I got a "perfect" first layer. I only lowered the z-axis but a pinch and it was super flat.

This is the real deal and if you have a T300, just save time and get this. It's worth it! 5 Stars!!!