Мини-штативы

I Printed this three times once horizontally with supports it had a lot of issues but was functional. The next two were vertical prints. The first of the vertical prints I only printed with 50% infill, it looked nice but one of the legs broke off when I tried to separate them. The last was printed with 100% infill that last leg was still a booger to open up. In the end it looked nice.

I thank Walter for the interesting and neat design.

I topped it with a Arducam for my Octoprint / Raspberry camera. I remixed the case from three different sources.

https://www.thingiverse.com/thing:3152242

I need to take a better picture of the Tripod thingiverse cropped the photo and removed most of the Tripod.